Just done an update, so I have 6.6.28 and matching firmware.
I am happy to report that on boot up, I now see the screen.
Can someone clarify for me.
I don't seem to have any touchscreen input.
If I run evtest, I see
event0,1 associated with hdmi-0
event2,3 associated with hdmi-1
event4 is 10-0038 generic ft5x06 (79)
which should be the touchscreen, I believe. However, if I run evtest, I see it reporting what events are supported, but there are no events.
I am going to disassemble the unit, check the cabling, and reassemble, but it was all working before I swapped out the SD card for one with bookworm on it.
Any other tips or requests on how I can investigate further?
I am happy to report that on boot up, I now see the screen.
Can someone clarify for me.
I don't seem to have any touchscreen input.
If I run evtest, I see
event0,1 associated with hdmi-0
event2,3 associated with hdmi-1
event4 is 10-0038 generic ft5x06 (79)
which should be the touchscreen, I believe. However, if I run evtest, I see it reporting what events are supported, but there are no events.
I am going to disassemble the unit, check the cabling, and reassemble, but it was all working before I swapped out the SD card for one with bookworm on it.
Any other tips or requests on how I can investigate further?
Statistics: Posted by SteveSpencer — Fri Apr 26, 2024 1:22 pm