Thanks for the help Dougie Lawson . I am writing this post from my class which starts at 9 so can't really post images rn. I'll do that once I reach home after 4 maybe. For now I tested all components again and realised 3 of my a4988 are actually corroded and don't work properly. I have ordered some new ones the tmc2208 . They are a little expensive but I had enough pocket money saved up. I am also gonna buy a cnc shield v3 but control it with a raspberry Pi Pico w with wires. I know it sounds stupid to use a shield for that but that's fine cause 4 expansion boards for a4988 cost almost double that if the cnc shield and also the cnc can handle more voltage unlike the expansion boards which can handle only 9 or maximum 12 v .
Statistics: Posted by DSBPARTH — Wed May 15, 2024 3:20 am