no messages and nothing in the logs because the pi is instant "dead" when zigbee2mqtt is accessing the zigbee-stick.Are there any messages that indicate power is an issue?
but as it was tested (in the link above from the zigbee2mqtt forum) with an active usb hub it works without problems.
so, yes i am sure that is a power issue.
something very bad happend after firmware 6.1.x
i made a stress test last night with the old raspi firmware and had not a single problem.
but all the firmwares after 6.1 freezes the rpi3 on first access to the usb-stick
Statistics: Posted by aloisderdritte — Wed Jun 05, 2024 8:25 am